MORES Upgrade Kit
Expedited express via FedEx: USD 37.67
Standard registered via Correo Argentino: USD 27.90
__________
33/45 Upgrade kit for Rega turntables: Butyl Gripping Subplatter, 33/45 pulley, Butyl Belt
This high performance sub-platter has been specifically designed for used with Rega turntables. We also manufacture other high performance sub-platters for other Rega models, including Rega RP6 too.
The precision assembly of this sub-platter integrates ideal components into a single sub-platter design which is not available anywhere else – polished aircraft grade aluminium hub (6061-T6 grade aluminium) with low carbon stainless steel extended spindle (316L) and dual butyl rings to grip the platter and isolate it from vibration.
Use of this single precision assembly sub-platter will enhance the already excellent performance of your Rega turntable in a number of areas:
SPEED STABILITY
- The diameter of the polished aircraft grade aluminium hub is controlled with better precision than the injection moulded plastic Rega hub, for enhanced speed stability / timing.
- Dual pulley and double belt SYSTEM could be be fitted with this sub-platter.
Note: we also supply dual pulleys and belts for this.
PLATTER PROTECTION
- The dual butyl rings system, grip and protect the platter to cause scratches or wear.
LOWER NOISE FLOOR
- The butyl rings isolate the platter from unwanted bearing vibration – lowering the noise floor.
- Stainless steel shaft and matching precision ball bearing lower noise floor and will not wear after 8,000 hours use (a life time!).
RECORD CLAMP
- The extended low carbon high tensile steel shaft enables a wide range of record clamp and stabilisers to be used – which further enhance the sound quality.
High Precision tolerances are applied during the manufacture of this sub-platter to ensure low coefficient of friction in use.
METAL PRECISSION MACHINED 33 1/3 - 45 RPM PULLEY FOR REGA TURNTABLES
- Easy plug & play system: no threatening glue. No screw clamps.
HIGH QUALITY BUTYL DRIVE BELT
- No joints
- Excelent gripping
- it's suitable for rega models RP1, RP2, RP3, etc.
Maximum height oscilation at the edge of a Rega original platter: 0.15 mm
Aluminium 33/45 pulley (optional upgrade to brass pulley).
Butyl rubber belts.
Ceramic zirconia oxide ball bearing
Optimal for MDF/Fiber/Resin Platters.
For Rega RP1, RP2, P1 or any Rega model that work with a 11.5 mm hub heigh subplatter and with a MDF/Fiber/Resin platter.
KIT IS CUSTOMIZED FOR 50 OR 60 HZ, JUST NOTIFY YOUR LOCAL POWER SYSTEM. WE´LL DO THE REST.